5a
Inoculating the Flexicult™ Test
- Label the test with the patient’s details. This is best done on the side of the lower half of the test.
- Pour the urine over all test sections. Approximately 5ml of urine is adequate. If only a small volume of urine is used (minimum 2.5ml) then this can be distributed onto the surface of the test with a disposable pastette.
- Gently rotate the test to allow urine to fully cover all the sections.
- Pour off the excess urine after ~5 seconds.
- Replace lid. The test should now be put into the incubator.